Near the beginning

Nugget gets covered in bearing grease

Finally, a place to put those Apple stickers!

So far, so good.

The start of Day 2 - the cars are kicked out of the garage.

Here we have three 21 inch lengths of 2x12 in the front of the trailer. Nugget drilled holes in the wood, and then we secured them in place with bolts, nuts, and washers.

A close up of the boards bolted to the trailer.

Nugget screws in the bracket that will hold the pole that will hold the tires.

Nugget screws in the piece that will hold the bars in place.

The first of the boards that will hold the "toolbox" is secured.

The second toolbox board goes in. These are attached in the same way as the boards on the front, except since the back of the middle bar lacks a lip, these are attached to the top of the bars, rathe than flush with the top of the bars.

This is the mounting of the toolbox. Nugget's old cable running days caught up with him (IMO) here. Those are the plates you'd normally find on a wall if you reroute a switch/plug somewhere else. They're buffered with a thin "laptop" mousepad. Wood screws have that pinned to those 2 inch thick boards.

The finished trailer is partially disassembled (poles and tires removed) before being leaned against the wall.

Now with bikes in front and cars parked. It fits!